Compatibility Chart:
Get Expert Help
Install Notes
Installation Instructions for T-Connector Adapter
Part Numbers:
- 118391
Tools Required:
- Drill with 3/32" drill bit.
- Test light or trailer for verification.
Step-by-Step Instructions:
-
Locate the Vehicle’s Harness Area:
- Open the rear tailgate and locate the vehicle’s jack storage compartment on the driver’s side.
- Remove the panel and tire jack to access the harness area.
-
Find the Trailer Harness Connector:
- Inside the driver’s side jack compartment, locate the vehicle’s trailer harness connector.
- This is a 6-pin connector taped to the vehicle’s wiring harness near the floor of the jack compartment.
-
Install the T-Connector:
- Remove the tape on the vehicle’s 6-pin connector.
- Plug the T-Connector into the vehicle’s trailer plug harness.
- Ensure the T-Connector is fully inserted with locking tabs in place.
-
Ground the White Wire:
- Locate a suitable grounding point near the connector, such as the vehicle’s frame or crossmember.
- Clean the grounding area to remove dirt and rustproofing.
- Drill a 3/32" hole and secure the white wire using the provided eyelet and screw.
Caution:
- Verify what is behind any surface prior to drilling to avoid damage to the vehicle or personal injury.
- Do not drill into exposed surfaces.
-
Test the Installation:
- Use a test light or trailer to verify the T-Connector’s functionality.
- Ensure all connections are complete for the T-Connector to function properly.
-
Store the 4-Flat Connector:
- When not in use, store the 4-flat connector in the jack storage compartment.
Specifications:
- Max. stop/turn light: 1 per side (2.1 amps).
- Max. tail lights: (5 amps).
Safety Notes:
- Overloading circuits can cause fires. Do not exceed the towing manufacturer’s rating or the unit specifications.
- Follow all warnings and installation instructions carefully.
Manufacturer Notes:
- Refer to the vehicle owner’s manual for additional guidance.
- Test thoroughly to ensure proper installation.